Home Forums General Technical Help indicators

  • This topic has 5 replies, 3 voices, and was last updated by adam.
Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #12410
    adam
    Participant

      indicators stopped working, i tried right hand indicator did not work, left hand indicator did work then stopped.
      I have check the fuse it look fine,i think its the flasher unit as it felt quite warm.
      has any one had the same problem.
      cheers adam 105e. :( :( :(

      #23631
      Terry
      Participant
        Club Member

        Hi Adam.
        I’ve had a similar problem with my indicators and I found that by moving the flasher unit to a vertical or horizontal position the flasher starts working again. I’ve now got mine laying horizontal on top of the wiring behind the speedometer and it now works ok. The problem usual happens if I’ve done anything around the wiring and moved the flasher unit. Give it a try. It might work.
        Terry

        #23634
        adam
        Participant

          Cheers terry i will give that a try.

          #23645
          adam
          Participant

            if the flasher unit does not work ,i would think the indicators would still come on butt not flash.
            I have change the fuse still not working.
            Iam now thinking is it the indicator stalk on steering column.
            Is there any wires behind speedo which could stop the indicators from working.
            can some one please help. :( :( :(
            cheers adam 105e.

            #23651
            paddi
            Participant
              Club Member

              Hi Adam – the wires that come off the stalk run down under the plastic steering column shroud and come out at the end of the shroud. You can check the wires going into the union block as they sometimes need wiggling!
              It sounds to me like an earth or flasher unit problem though if it definitely isn’t the fuse. Try running a long wire from the live battery terminal to the live wire in each light unit and check that the units are earthing and the bulbs are OK. then work back from there (live wire to flasher unit etc). In my experience when the stalks go or get gummed up they still work for some time when you wiggle them so if it’s just gone straight away it’s more likely to be earth/fuse or flasher unit. I’ve had flasher units fail that don’t allow the bulbs to light as well as having some that light but don’t flash – sometimes just tapping the unit gets it to flash for a few seconds – they are a bit temperamental when they start going!

              Hope this helps!

              #23653
              adam
              Participant

                hi paddi ,i think i will buy a new flasher unit before i start checking all the wireing thank for all your advise.
                cheers adam 105e.

              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.