Home › Forums › General › General topics › Rer Wheel Bearings

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 18, 2006 at 8:20 pm #10127
    RhinoNeil
    Participant

    Hi …
    Is it possible to fit new rear wheel bearings without useing a hidrolic press?

    July 19, 2006 at 3:34 pm #15351
    Anonymous
    Participant

    It is but you still need certain bits of equipment.
    If you send me your email address to [email protected] I will email the article I did a while back for club mag.

    Most of the tech articles I have done in the past will be appearing on the revamped club website tech page over the next few months. Some of them just need tweaking and updating, as soon as I have done this I will be passing them on to the lovely Webmaster who will then post them for everyones benefit.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.