Forum Replies Created

Viewing 10 posts - 1 through 15 (of 487 total)
  • Author
    Posts
  • in reply to: Rocker cover cap #75661
    andrew sales
    Participant
    Club Member

    I fitted a small breither on the side of my alloy rocker cover also got a couple on the top at the back. The new caps are the same as mini alloy rocker covers as i bought one recently.??

    in reply to: Upholstery in essex #68776
    andrew sales
    Participant
    Club Member

    Try JDA Trimming Maidstone 01622 746969 or 07515571469 ask for James

    in reply to: Melton disc conversion #62546
    andrew sales
    Participant
    Club Member

    Hello just wondering did you order the right brackets for the escort brake calipers as I see they are different for the Nissan Micra calipers as they use both ?. I recently worked on an Anglia with a disc brake conversion & if fitted well just a thought. ??

    in reply to: Where is the Ballast Resistor located #62446
    andrew sales
    Participant
    Club Member

    Hello Andrew you will be looking for a wire if I remember rightly it’s a purple wire I could be wrong about the colour.??

    in reply to: Shuddering, lurching then stalling in 3rd and 4th gear #57560
    andrew sales
    Participant
    Club Member

    Just another thought have you removed & cleaned the fuel tank ?. I had a problem a couple of years ago when an Anglia kept cutting out I removed the fuel tank only to find a plastic bag in the tank so must of kept getting sucked up now & again. Cured the problem.?

    in reply to: Shuddering, lurching then stalling in 3rd and 4th gear #57025
    andrew sales
    Participant
    Club Member

    Hello Philip did it run ok before you made all the changes ?. Being a late 1966 Anglia are you sure it wasn’t a ballast resister system previously ?. I had a similar problem with an Anglia recently. The car was originally aballast resister system but somebody had fitted a standard coil this was fitted the wrong way around firstly. What I found the car would not rev under load. I see you have fitted an electronic distributor you may find out you are not getting enough power to the distributor as the ballast system has a reduced voltage. What I did was fitted a Lucas distributor of an earlier Anglia & cut out the ballast resister wire which was faulty. Was the new distributor for a positive earth vehicle or a negative earth vehicle as I believe they are different. Have you got the wires the right way round if you have changed the polarity . It caused me ours scratching my head. Does the car rev in when stationary ? or does it have a bad flat spot ?. What I would do is check the voltage from your ignition switch to the distributor because it could be only around 9 volts as originally it would only have 12 volts on cranking if it had a ballast system. I hope this is of help it may not be your problem but its worth checking atb Andy.??

    in reply to: 307e complete stainless exhaust system wanted #56079
    andrew sales
    Participant
    Club Member

    Hello all just to let you know I have found a stainless exhaust Pipers Exhaust listed one on there site & will be with me in about a week.Thanks for the add.?

    in reply to: Ashtray keeps falling open #55606
    andrew sales
    Participant
    Club Member

    Hello Peter yes you need the 2 springs its better to fit them with small nuts & bolts which makes it easier atb Andy.?

    andrew sales
    Participant
    Club Member

    Hello John put me down for a place atb Andy.

    in reply to: New green van #34675
    andrew sales
    Participant
    Club Member

    Hello Paul how you getting on these days have you still got the batmobile car & the Anglia good to here from you atb Andy. :wink:

Viewing 10 posts - 1 through 15 (of 487 total)